Pimoroni 1.5M Cable for Wide Input SHIM
Pimoroni

Pimoroni 1.5M Cable for Wide Input SHIM

Regular price $3.95

This is a 1.5m long 3.5mm OD male to tinned wires cable, for the Pimoroni Wide Input SHIM. Note that this cable requires soldering for connecting to the Wide Input SHIM.

Usage

You can supply a range input voltages to Wide Input SHIM, either through the centre positive 3.5mm outer diameter barrel jack connector, or through the two broken-out + and - pins on the SHIM.

The board will provide 5V/2A output (through the GPIO to the Pi) at input voltages of 5V to 16V. Current drops to 1.5A at 4V, and 1A at 3V.

Pulling the EN (enable) pin to ground will cut the 5V voltage output, although it should be noted that you should shut your Pi down cleanly before doing this!

Notes

  • This item is an accessory for the Wide Input SHIM (available separately)
  • Using both micro-USB power and Wide Input SHIM power at the same time is not recommended with Pi Zero / W where there is no protection against back-powering

Share this Product

Customer Reviews

No reviews yet
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)